Editing NHRA-legal roll bar (section)
Jump to:
navigation
,
search
====Cross-braces==== <blockquote> ''"Roll bar must be adequately supported or cross-braced to prevent forward or lateral collapse."'' </blockquote> Forward or rearward "lozenging" or collapse is prevented by the two diagonal (as viewed from the side of the car) bars (rear braces) which connect to the top of the B bar and run down through the package tray and into the trunk area in the rear, or through the cab rear window/rear cab sheetmetal onto the floor of the bed if we're talking pickup truck, forming a triangular support to the B bar when the car/truck is viewed from the side. Lateral (sideways) collapse is prevented by the cross bar which runs from the left (or driver's side) of the B bar to the right (or passenger's side) of the B bar. This cross bar is installed at the driver's shoulder height with the driver seated in his/her driving position and also serves as the shoulder belt anchor point. It should be noted that many builders also install a diagonal "D" bar (as viewed from the front or rear of the car) from the "B" bar corner at the driver's helmet down to the other side of the car at the bar end/floor to further prevent structural failure.
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent