Editing Intake manifold (section)
Jump to:
navigation
,
search
===Removing the heat shield=== During use, the heat shield can become occluded with built up carbon. This can be cleaned out by removing the heat shield. Use a sharp, gradually tapered 1/4" chisel to get up under the edges of the rivets (you might need to grind a chisel down to get the best tip. Don't grind until red hot or the temper will be lost). The rivets used on Chevy intakes usually have spiral ridges on them that help hold them in position, so they tend to turn as they come out. If a rivet gets broken off in the removal process, do not worry. Leave the broken piece in the intake. Move a little to one side of the hole where the broken rivet is located and center punch and drill a new hole through the heat shield into the intake to receive a replacement rivet. A depth stop can be used to prevent the hole from being drilled too deep.
|
Editing help
(opens in new window)
Personal tools
Log in / create account
Namespaces
Page
Discussion
Variants
Views
Read
Edit
View history
Actions
Search
Navigation
Main Page
Recent changes
Random page
Help
All articles
Start a new article
Hotrodders forum
Categories
Best articles
Body and exterior
Brakes
Cooling
Electrical
Engine
Fasteners
Frame
Garage and shop
General hotrodding
Identification and decoding
Interior
Rearend
Safety
Steering
Suspension
Tires
Tools
Transmission
Troubleshooting
Wheels
Toolbox
What links here
Related changes
Special pages
Terms of Use
Copyright
Privacy Policy
Your Privacy Choices
Manage Consent