Spraying bed liner material on floorboards and wheel wells

From Crankshaft Coalition Wiki

When you are going to spray bed liner material,mask everything you dont want to spray.

If you are using a 1 gallon can stir material,then punch a hole in center of can lid, big enough to take the size hose you are using, insert hose into can, about 1/2 inch from bottom then make a small vent hole also in lid. put lid back on can tightly (i also tape mine using duct tape.after you finish spraying,to clean gun and hose,put finger over outlet of gun,pull trigger,that will put the excess material back into the can. then using a 1 gal plastic milk jug,put about 1/4 gallon of acetone (or lacquer thinner in jug,put hose in jug, and spray ,then finger,on outlet,then spray,do this about 4 or 5 times. now the acetone in the jug will be dirty. change to clean acetone or lacquer thinner,spray,finger,spray,finger change jug material until you only get clean material. have fun,and wear a mask and throw away clothes...